Sticking plaster cracked#
Sticking plaster Patch#

If staining continues to persist, consider ‘dry lining’ by fixing battens to the wall and applying laths and lime plaster.

If you decide to replaster stained areas, when the problem is not severe it is sometimes suggested to use a slurry of cow dung painted on to the masonry before applying new lime plaster.

Where staining appears through a chimney breast it may be necessary to replaster.

Ensure the wall has been allowed to dry out fully before applying plaster.

Always treat the cause of any damp problems, not the symptoms.

Soot staining from flues can often be seen on the surface above a fireplace. If these continue to come to the surface, plaster may have to be stripped. Where damp is present, salts may pose a problem. Unlike modern plasters, lime plasters that have become wet generally dry out with their integrity intact so need not be removed.

Use a steam stripper to remove stubborn coatings, being careful not to allow steam to penetrate the plaster.

Apply warm water or proprietary wallpaper stripper with a sponge or brush.

Gently use a scraper but avoid scoring through the surface into the plaster.

Always undertake a test first on a small unobtrusive area.

When removing, proceed with care and be aware that wallpaper may be acting as a support to defective plaster underneath.

Wallpapers, paints and other finishes can spoil the appearance of plaster surfaces and may trap moisture. Where the bond with laths has failed, reinforce by pouring fresh plaster from above and strengthening with a jute scrim set into this and secured to the joists.Always use screws for any fixings to avoid vibrations to fragile ceilings.Investigate from above if access is available from a loft or by carefully lifting floorboards.Problems with ceilings frequently result from the plaster bond having failed, structural movement, failure of joists, damp problems and rotten or beetle-infested laths.

Sticking plaster cracked#

Removing a loose section of old lime plaster Mending sagging or cracked ceilings Alternatively, gypsum may sometimes be added to a lime plaster mix for the same purpose.

Sticking plaster Patch#

To patch repair plasterwork, slightly treat the exposed edges of the existing plaster with water or diluted PVA (one part to 10 of water) to control suction and prevent cracking.Cracks and pockmarks may be filled using matching plaster, or narrow ones with proprietary interior filler gauged with whiting.Make necessary repairs with appropriate traditional materials.Consult a structural engineer if in any doubt.Monitor cracks over a period of time by marking and dating their end point on the wall.Investigate bulges or anything larger than a hairline crack.Rake out thin cracks and fill with a good filler.Some cracks and bulges in plaster may be superficial or localised others result from failure of the masonry or timber beneath, or may indicate wider structural problems within the building. Inappropriate modern plasters and finishes.

DIY: Make plastering walls an easy job with our guide.

Rotten laths can result in plaster sagging or bowing. In the case of stud walls and ceilings, timber laths are fixed between the studs or joists and the plaster is pushed through the gaps between the laths.